Measuring technology
NOTICE
Select measured variables and channels here. Then you can perform various measurements.
Measurement technology is a digital signal acquisition and output. This means that the voltage signal is detected and saved within a few microseconds. These registered measured values are depicted as continuous signal curve on the screen in real time.
Just perform measurements under >Measurements<.
Use the measurements function for measuring and/or depicting the following measured variables:
- Voltage
- Current (with amp clamp)
- Resistance
Current measurements are allowed exclusively with the clamp meter from Hella Gutmann. Depending on the required measurement, different clamps are to be used.
A progress bar in the top toolbar indicates the remaining free storage capacity reserved for that in the diagnostic device.
Use >Loading measurement< to call up registered and saved measurements.
Use >Delete all measurements< to delete already registered and saved measurements.
CAUTION
Overvoltage
Fire hazard/danger of damage to the diagnostic device and its surroundings
Comply with the max. permitted voltage load of the oscilloscope channels