Configuring the Ethernet

Here you can make your network settings.

Proceed as follows to connect the diagnostic device to a network (router) via Ethernet interface:

  1. Plug in the Ethernet cable (not included in delivery contents) in the Ethernet ports of the mega macs X and the Ethernet remote station.
  2. Select > Settings.
  3. Select >Device<.
  4. Select >Ethernet<.
  5. Open the list under IP address mode with .
  6. If >Determine automatically (DHCP)< (recommended) is set, the DHCP server of the network will assign an IP address to the mega macs X automatically. This option is set ex works.
  7. If >Determine manually< is selected, enter a free network IP address, e.g. 192.168.246.002. under IP address.
  8. Select >Determine automatically (DHCP)< (recommended) or >Determine manually<.
  9. Click to >Connect<.
  10. The selection will be saved automatically.
  1. You can use the Ethernet connection now.