Performing Basic Settings

NOTICE

notice

First select a vehicle before doing any basic settings.

For more information about the vehicle selection read the sections Vehicle selection and CSM vehicle selection.

WARNING

warning

Wrong or incorrectly performed basic settings

Risk of injury or material damage to vehicles

Regard the following when performing basic settings:

1. Select the correct vehicle type.

2. Regard the window with information and instructions.

CAUTION

caution

Rolling of vehicle

Risk of injury or material damages

Proceed as follows before startup:

1. Apply the parking brake.

2. No gear is engaged.

3. Regard the window with information and instructions.

NOTICE

notice

Danger of short circuit and voltage peaks when connecting the OBD plug

Danger of destruction of automotive electronics

Switch off ignition before connecting the OBD plug to the vehicle.

Proceed as follows to perform the basic setting:

  1. Plug in the OBD plug in the vehicle's diagnostic connector.
  2. Select Diagnostics > Basic settings in the App launcher.
  3. Select the requested assembly.
  4. Select the requested system.
  5. Follow the instructions on the screen and start the procedure with >Start<.
  6. Regard the window with information and instructions.
  7. Communication to vehicle is being established.
  8. Follow the instructions on the screen.