Systems

Pre test of German exhaust emission analysis

Quick test of the exhaust-gas relevant parameters of an OBD vehicle. This test should be done before the actual exhaust-gas emission inspection.

Readiness code

Indication of the type of diagnostic connector.

Parameter

Indication of all emission-relevant parameters. The number of the available parameters depends on the vehicle.

Freeze frame data

Indication of ambient data (rpm, coolant temperature) of the stored fault code.

Permanent trouble codes

Indication of all permanent trouble codes that are emission-relevant.

Trouble code deletion

Deletion of all trouble codes from "Mode 2/3/7".

Oxygen sensor test results

Check and evaluation of oxygen sensor function. This mode is not supported at CAN bus protocols.

Result of sporadic system test

Indication of manufacturer-specific parameters.

Sporadic trouble codes

This mode displays all sporadic and emission-relevant trouble codes.

Actuator test

Here you can actuate the actuators that have been determined by the manufacturer as emission-relevant.

Vehicle Information

Here you can call up vehicle and system information, e.g., the VIN.

Inactive trouble codes

Here you can view freeze frame data as well as permanent and sporadic fault codes.