mega macs S 20 Installation

NOTICE

notice

The download of the mega macs S 20 application requires a Google account.

You can download and install the mega macs S 20 application from the Google Play Store.

NOTICE

notice

The installation requires power supply of the HG-VCI S 20. There are 2 options for that:

A: USB port at PC/tablet (Only use the enclosed USB cable for the connection!)

B: Diagnostic connection in the vehicle

Connect the HG-VCI S 20 to the vehicle only when ignition is switched off. Afterwards switch on the ignition again so that the HG-VCI S 20 has power supply.

Proceed as follows to install the mega macs S 20:

  1. Open the Google Play Store app in the display unit on which the mega macs S 20 shall be used.
  2. Enter mega macs S 20 in the search window.
  3. Select the mega macs S 20 application.
  4. Start the app download and regard the notes in the setup menu.

  5. NOTICE

    notice

    Hella Gutmann Login

    Use the e-mail address which has been stated in the order.

    An automatically generated e-mail with a link to the registration form will be sent to the specified e-mail address. A password-protected Hella Gutmann account can be created using this link. Logging in and installing the mega macs S 20 is only possible with these access data.

    If you already have a Hella Gutmann Account but if you have forgotten your password, you can reset the password. In this case you will receive an automatically generated e-mail with a link for password reset.

  6. After having entered the access data the system will try to establish a connection to the HG-VCI S 20.
  7. Data download is in progress.
  8. The download speed depends on the Internet speed.
  1. The installation of the mega macs S 20 is finished now.
  2. The SDI interface starts automatically after the installation.

 

The following video shows the procedure of initial start-up step by step: Click to the button to view the video.