Performing Automatic Service Resets

Proceed as follows to perform the automatic service reset:

  1. Perform steps 1 to 11 as described in section Vehicle selection.

  2. CAUTION

    caution

    Pulling off of the HG-VCI PC when actuating the clutch

    Risk of injury or material damages

    Proceed as follows before startup:

    1. Apply the parking brake.

    2. No gear is engaged.

    3. Regard the window with information and instructions.

  3. NOTICE

    notice

    Danger of short circuit and voltage peaks when connecting the HG-VCI PC

    Danger of destruction of automotive electronics

    Switch off ignition before connecting the HG-VCI PC to the vehicle.

  4. Connect the HG-VCI PC to the vehicle's diagnostic connection.
  5. Both LEDs of the HG-VCI PC flash.
  6. The HG-VCI PC is ready for operation.
  7. Select Diagnostics > Function > Service reset.

  8. NOTICE

    notice

    The selection of the following possibilities depends on the selected manufacturer and vehicle type:

    - Functions

    - Component groups

    - Systems

    - Data

  9. Select the requested system.
  10. Observe the info window.
  11. Call up the >Information< tab.
  12. Follow the instructions on the screen.
  13. Start the automatic service reset with .
  14. Select the OBD plug and subsystem where necessary.
  15. Regard the window with information and instructions.
  16. Confirm the window with infos and instructions with .
  17. Communication to vehicle is being established. The service reset will be done automatically.
  18. The message Service interval reset appears if the service reset was successful.
  19. Confirm the info window with .