Performing Manual Service Resets

CAUTION

caution

Pulling off of the HG-VCI PC when actuating the clutch

Risk of injury or material damages

Proceed as follows before startup:

1. Apply the parking brake.

2. No gear is engaged.

3. Regard the window with information and instructions.

Proceed as follows to perform the manual service reset:

  1. Perform steps 1 to 11 as described in section Vehicle selection.

  2. CAUTION

    caution

    Pulling off of the HG-VCI PC when actuating the clutch

    Risk of injury or material damages

    Proceed as follows before startup:

    1. Apply the parking brake.

    2. No gear is engaged.

    3. Regard the window with information and instructions.

  3. NOTICE

    notice

    Danger of short circuit and voltage peaks when connecting the HG-VCI PC

    Danger of destruction of automotive electronics

    Switch off ignition before connecting the HG-VCI PC to the vehicle.

  4. Connect the HG-VCI PC to the vehicle's diagnostic connection.
  5. Both LEDs of the HG-VCI PC flash.
  6. The HG-VCI PC is ready for operation.
  7. Select Diagnostics > Function > Service reset.

  8. NOTICE

    notice

    The selection of the following possibilities depends on the selected manufacturer and vehicle type:

    - Functions

    - Component groups

    - Systems

    - Data

  9. Select the requested system.
  10. Observe the info window.
  11. Call up the >Information< tab.
  12. Follow the instructions on the screen.
  13. Start the manual service reset with .
  14. Select the OBD plug in the subsystem where necessary.
  15. Regard the window with information and instructions.
  16. Follow the instructions on the screen.
  17. Confirm the performed service reset with .