OBD
Indication of the individual OBD modes for petrol and Diesel vehicles as well as the pre-test of the German exhaust-emission check and the VW short trip.
OBD modes and OBD tests | |
|---|---|
Pre test of German exhaust emission analysis | Quick test of the exhaust-gas relevant parameters of an OBD vehicle. This test should be done before the actual exhaust-gas emission inspection. |
Readiness code | Indication of the type of diagnostic connector. |
Parameter | Indication of all emission-relevant parameters. The number of the available parameters depends on the vehicle. |
Freeze frame data | Indication of ambient data (rpm, coolant temperature) of the stored fault code. |
Permanent trouble codes | Indication of all permanent trouble codes that are emission-relevant. |
Trouble code deletion | Deletion of all trouble codes from "Mode 2/3/7". |
Oxygen sensor test results | Check and evaluation of oxygen sensor function. This mode is not supported at CAN bus protocols. |
Result of sporadic system test | Indication of manufacturer-specific parameters. |
Sporadic trouble codes | This mode displays all sporadic and emission-relevant trouble codes. |
Actuator test | Here you can actuate the actuators that have been determined by the manufacturer as emission-relevant. |
Vehicle Information | Here you can call up vehicle and system information, e.g., the VIN. |
Inactive trouble codes | Here you can view freeze frame data as well as permanent and sporadic fault codes. |