Performing HG-VCI PC Diagnostics

This diagnostics is used to test the functionality of Bluetooth® connection for defects to determine data losses.

Proceed as follows to perform HG-VCI PC diagnostics:

  1. Insert the Bluetooth® adapter into the USB port of the PC.
  3. Select Settings > Test functions.

  4. CAUTION

    caution

    Pulling off of the HG-VCI PC when actuating the clutch

    Risk of injury or material damages

    Proceed as follows before startup:

    1. Apply the parking brake.

    2. No gear is engaged.

    3. Regard the window with information and instructions.

  5. NOTICE

    notice

    Danger of short circuit and voltage peaks when connecting the HG-VCI PC

    Danger of destruction of automotive electronics

    Switch off ignition before connecting the HG-VCI PC to the vehicle.

  6. Connect the HG-VCI PC to the vehicle's diagnostic connection.
  7. Both LEDs of the HG-VCI PC flash.
  8. The HG-VCI PC is ready for operation.
  9. Start VCI diagnostics (Bluetooth) with .
  10. The Wireless diagnostics window appears. The Bluetooth® function is being tested.
  1. VCI diagnostics is completed successfully if 0 is displayed under Defective protocols and Diagnostics complete is displayed under Status.