Performing Automatic Service Resets
Proceed as follows to perform the automatic service reset:
- Perform steps 1 to 11 as described in section Vehicle selection.
CAUTION
Pulling off of the HG-VCI PC when actuating the clutch
Risk of injury or material damages
Proceed as follows before startup:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with information and instructions.
NOTICE
Danger of short circuit and voltage peaks when connecting the HG-VCI PC
Danger of destruction of automotive electronics
Switch off ignition before connecting the HG-VCI PC to the vehicle.
- Connect the HG-VCI PC to the vehicle's diagnostic connection.
- Both LEDs of the HG-VCI PC flash.
- The HG-VCI PC is ready for operation.
- Select > > .
NOTICE
The selection of the following possibilities depends on the selected manufacturer and vehicle type:
- Functions
- Component groups
- Systems
- Data
- Select the requested system.
- Observe the info window.
- Call up the >Information< tab.
- Follow the instructions on the screen.
- Start the automatic service reset with .
- Select the OBD plug and subsystem where necessary.
- Regard the window with information and instructions.
- Confirm the window with infos and instructions with .
- Communication to vehicle is being established. The service reset will be done automatically.
- The message Service interval reset appears if the service reset was successful.
- Confirm the info window with .