Printing with Standard PC Printer

Here you can set the standard printer for printing with the PC on which the mega macs PC software is installed.

For this, the mega macs PC software must forward the data to be printed to the Hella Gutmann Drivers. Then the Hella Gutmann Drivers sends the data to the standard printer of the system.

Proceed as follows to print out results with the standard printer:

  1. Select Settings > Interfaces.
  2. Select >Printer<.
  3. Open a list under Interface with .
  4. Select >Gutmann Portal<.
  5. The selection will be saved automatically.
  6. Use to open the virtual keypad under top (mm). The margins are set ex works to 15 mm.
  7. Delete the number set ex works with or where necessary.
  8. Enter the requested height of the margins in mm.
  9. Confirm your entry with .
  10. The input will be saved automatically.
  11. Repeat steps 5-8 for further entries.
  12. Where necessary, activate the check box Blank out HGS company logo to print out results without the company logo of Hella Gutmann. This function enables hard-copy printouts on printed paper.
  13. Now you can start printing via PC.