HG-VCI Update
NOTICE

Insufficient voltage supply
System data loss
Do not switch off the PC and the HG-VCI PC during the HG-VCI PC update and do not disconnect them from voltage supply.
Ensure sufficient voltage supply.
Proceed as follows to start the HG-VCI PC update:
- Select > in the main menu.
- Select the >HG-VCI PC< tab.
CAUTION
Pulling off of the HG-VCI PC when actuating the clutch
Risk of injury or material damages
Proceed as follows before startup:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with information and instructions.
NOTICE
Danger of short circuit and voltage peaks when connecting the HG-VCI PC
Danger of destruction of automotive electronics
Switch off ignition before connecting the HG-VCI PC to the vehicle.
- Connect the HG-VCI PC to the vehicle's diagnostic connection.
- Both LEDs of the HG-VCI PC flash.
- The HG-VCI PC is ready for operation.
- Push
to Start HG-VCI PC update.
- Regard the window with information and instructions.
- Confirm the window with infos and instructions with
.
- The HG-VCI PC update will start. Data is copied from the mega macs PC to HG-VCI PC.
- The message HG-VCI PC update successfully done appears if the update was successful.