Attaching the Wheel Clamp Modules SE / WA to the Rear Wheels

Proceed as follows to attach the wheel clamp module SE / WA to the rear wheel:

  1. Attach one wheel clamp module SE / WA on the left and right rear wheel respectively.

  2. WARNING

    warning

    Sharp object

    Risk of injury or piercing

    Always position the wheel clamp "Distance" on the rim flange or tire using the handle.

  3. CAUTION

    caution

    Scratching of surfaces

    Damage to wheel rims

    Always attach the spacer-set to the rim flange or tire.

  4. With wheel clamp module SE:
  6. With wheel clamp module WA:
  8. Loosen the set screw of the shaft with the cross connector.
  9. Now you can adjust the height of the shaft with the cross connector.
  10. Align the shaft with the cross connector (66 / 69) of the wheel clamp module SE / WA to the wheel center (67 / 70).
  11. Wheel clamp module SE:
  13. Wheel clamp module WA:
  15. Align the scales of the wheel clamp module SE / WA in right angle.

  16. NOTICE

    notice

    Pay attention that the level gauge bubble of the wheel clamp module SE is centred.

    The wheel clamp module WA has a third contact cylinder (68), so that the test of the centered alignment with the level gauge bubble is not necessary.

    Only if the wheel clamp module SE / WA is attached horizontally and centered to the wheel center you can position the CSC-Tool Digital (2023).

  1. Now both wheel clamp modules SE / WA are correctly attached to the rear wheels.