Working with the CSC-Tool Digital

The following steps are necessary to be able to work with the CSC-Tool Digital (2023):

1. Attach the wheel clamps "Distance" to the front wheels (provided that distance measurement using the wheel center is demanded by the diagnostic device).
2. Attach the wheel clamps SE / wheel clamp modules WA to the rear wheels.
3. Perform the vehicle-specific preparations for use.
4. Place the CSC-Tool Digital (2023) at the right distance, centered and parallel (referred to the rear axle) in front of the vehicle.
5. Level the CSC-Tool Digital (2023).
6. Adjust the height of the CSC reference panel.

The individual steps are described below.