Wheel Clamp Module SE (Optional)
35 | Handle (Transport the wheel clamp module SE easily with this handle.) | 36 | Scale of wheel clamp module SE (Here you can check if the CSC-Tool Digital is placed parallel (referred to the rear axle) to the vehicle.) |
37 | Set screw of scale (Use this screw to set and fix the scale.) | 38 | Attachment bracket for vehicles (Use it to attach the wheel clamp module SE to the tire.) |
39 | Shaft with cross connector | 40 | Set screw shaft with cross connector (Use this set screw to adjust the height of the shaft with the cross connector.) |
41 | Contact cylinder (The cylinder serves to correctly position the wheel clamp module SE against the tire or the rim.) | 42 | Level gauge (Use the level gauge to check whether the laser module is positioned vertically.) |
43 | Level gauge (Use the level gauge to check whether the laser module is positioned horizontally.) | 44 | Level gauge (Use the level gauge to check whether the laser module is positioned horizontally.) |
45 | Lasere module (Use the laser to project the real value to the scale of the cross member.) | 46 | Contact cylinder (The cylinder serves to correctly position the wheel clamp module SE against the tire or the rim.) |
47 | Level gauge (Use the level gauge to check whether the wheel clamp module SE is attached horizontally.) |
48 | Battery compartment cover (Insert two batteries type AA here.) | 49 | Switch (Switch the laser on and off.) |
50 | Mounting bolt (Use it to adjust and fix the laser module.) | 51 | Laser beam output (The laser beam comes out here. Use the laser beam to read the actual value at the scales of the cross member and at the wheel clamp module SE.) |